Transducer mount Question

[Polwarth]

Hi all, I am about to change to an in hull mount for my transducer. So I have been reading and watching you tube.

Seems there is a variety of ways to mount them from epoxy to silicon and even a container mounted then filled with water when you get there.

I like the idea of a tube product such, but epoxy would be better for getting the air bubbles out.

What have people done, I would love to have do a good job that I wont regret once its in.

Cheers in advance.

[awondering]

I emptied a wholee tube of selleys all clear into one the channels inside the hull and just slowly pushed the transducer into that, gave it a week and its sweet as some of these things may appear more difficult than the reality of it mate...

[Marc N]

I emptied a wholee tube of selleys all clear into one the channels inside the hull and just slowly pushed the transducer into that, gave it a week and its sweet as some of these things may appear more difficult than the reality of it mate...

That sounds like a go...

Selleys All Clear?

This stuff?



Cheers

Marc

[eynon]

get the big tube for glue guns

[awondering]

I emptied a wholee tube of selleys all clear into one the channels inside the hull and just slowly pushed the transducer into that, gave it a week and its sweet as some of these things may appear more difficult than the reality of it mate...

That sounds like a go...

Selleys All Clear?

This stuff?



Cheers

Marc

Might have been this one >>> https://www.bunnings.co.nz/selleys-260g ... _p00239341

[Stinky inky]

Def get a tube much easier to apply with a caulking gun . I did a similar install myself made a foam well for the transducer to sit in worked pretty well and not too messy either.