The hatch lid has seen a few fish finders and mods over the years by myself and previous owners, it had quite a few holes drilled in it which I'd filled with epoxy glue every now and then but with all of them it was starting to look like crap so I gave it a good sand, spray with spray filler, sand, spray filler again, sand then a few coats of matt black to give it a new look, reckon it turned out ok in the end

Also you may have seen my last post on the new Raymarine Dragonfly install, it was very temporary so time to make it a bit more permanent. I fitted the inspection hatch and glued the transducer to the hull under my right calf.
Plan was to give the whole kayak a good cut an polish but time ran out so I'll save that for another weekend
